Thermogroup Ladder Heated Towel Rail 12V Round W600 X H800mm

Thermogroup Ladder Heated Towel Rail 12V

Heated Towel Rails are an affordable luxury for every bathroom for warming and drying your towels.
The SRB4412 Heated Towel Rail is a 600×800 7 bar brushed stainless steel ladder rail.

The Brushed Stainless finish is very similar to a Brushed Nickel finish and can be used to compliment your Brushed Nickel tapware.

The SRB4412 electric towel dryer is a 12v unit, this means that it can be installed close to a wet area in the bathroom.
The rail comes supplied with a transformer which reduces the incoming voltage from 240v to 12v.
The rail will still operate at the same temperature and use the same amount of electricity as an equivalent 240v rail as the wattage is the same, however, the rail is operating at a lower voltage.

The rail has a wiring point on both the left and right-hand side of the rail and can be wired at either the top or bottom of the rail. As it is a 12v unit and needs to be wired to a transformer the rail can only be hardwired.

The electric towel rail is designed to rapidly heat up and reach a temperature of around 45-55 degrees.
The rail can be operated using an on/off switch however we recommend using a timer to allow you to set and forget and control your running costs.
Output: 90 Watts
Wiring Position: Multiflex wiring on all 4 legs
Voltage: 12 Volt
No of Bars: 7
IP Rating: IP55
Construction: 304 Quality Stainless Steel
Wiring Type: Concealed wiring only
Distance Between Mounting Points (Left to Right): 600mm

View Thermogroup Ladder Heated Towel Rail 12V  Product Specs

Colours of the Thermogroup SRB4412 Ladder Heated Towel Rail 12V may vary. Images are for illustration purposes only and the colour or finish may vary from the actual product.

PLEASE NOTE: Thermogroup SRB4412 Ladder Heated Towel Rail 12V specifications are for information purposes only. Whilst every effort has been made to ensure the product specifications are accurate, due to continuing product development and improvement the specifications are subject to change. Specifications can be used to rough in and fit timber supports in the wall however we recommend no holes are drilled without having the product on site or verifying the details with the manufacturer. Thermogroup cannot be held liable or responsible for errors due to updated specifications.

For product enquiries please feel free to contact us. One of our customer service team members will be in touch as soon as possible.