Thermogroup Jeeves Heated Towel Rail W620 X H555mm

Thermogroup Jeeves Heated Towel Rail

Heated Towel Rails are an affordable luxury for every bathroom for warming and drying your towels.
The Jeeves Rails are Liquid Filled, this means the heated towel rail is filled with liquid and heated by an electric element.
As the water particles increase in temperature they circulate in the rail thereby heating the entire rail.
Liquid Filled rails run at a higher temperature than an equivalent electric heated towel rail as they are designed to add some heat to the bathroom as well as warming and drying your towels.

The M62SPR is a Polished Stainless rail that features 7 horizontal bars and an additional 4 on the heated shelf.
The high number of bars helps to contribute to the increased heat surface area.
The Jeeves Heated Towel Rail comes as a prefilled unit meaning it is simply wired up like a standard towel rail on site.
If the element was ever to fail it can be replaced without needing to replace the rail.
The wiring position for the rail comes as standard on the right hand side.

A Liquid Filled Heated Towel Rail will take closer to an hour to reach a maximum temperature of around 55-60 degrees.
The rail can be operated using an on/off switch however we recommend using a timer to allow you to set and forget and control your running costs.
Output: 120 Watts
Wiring Position: Bottom Right Hand Concealed Wiring
Voltage: 240 Volt
No of Bars: 7
IP Rating: IPX5
Construction: 304 Quality Stainless Steel
Distance Between Mounting Points (Left to Right): 620mm

View Thermogroup Jeeves Heated Towel Rail  Product Specs

Colours of the Thermogroup M62SPR Jeeves Heated Towel Rail may vary. Images are for illustration purposes only and the colour or finish may vary from the actual product.

PLEASE NOTE: Thermogroup M62SPR Jeeves Heated Towel Rail specifications are for information purposes only. Whilst every effort has been made to ensure the product specifications are accurate, due to continuing product development and improvement the specifications are subject to change. Specifications can be used to rough in and fit timber supports in the wall however we recommend no holes are drilled without having the product on site or verifying the details with the manufacturer. Thermogroup cannot be held liable or responsible for errors due to updated specifications.

For product enquiries please feel free to contact us. One of our customer service team members will be in touch as soon as possible.